Re: Saving the original paintwork and trunk emblem - 1951 200 barn findand
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
I Realized last night what a saving grace this site is as I struggled to unsuccessfully try and remove my rear hubs.
I realize I need to adjust the stat wheel but can't figure out how even after ready the service manual which says to "remove the adjusting hole covers From the backing plate" but don't know which bolts to remove to do so. Any help in getting this hub off is greatly appreciated!!!
Posted on: 2019/4/25 10:13
|
|||
1951 200 Deluxe Sedan Valiant Green Metallic
Vehicle #:2462 8372 |
||||
|
Re: Saving the original paintwork and trunk emblem - 1951 200 barn findand
|
||||
---|---|---|---|---|
Webmaster
![]() ![]() ![]() |
The adjustment hole is just a oblong cutout in the back of the backing plate. Most of the times, the cover is missing. If not, it either a sheetmetal or rubber plug that just snaps into the hole to help keep water and debris out.
The hole is just a bit bigger than the end of the brake spoon.
Posted on: 2019/4/25 10:19
|
|||
-BigKev
1954 Packard Clipper Deluxe Touring Sedan -> Registry | Project Blog 1937 Packard 115-C Convertible Coupe -> Registry | Project Blog |
||||
|
Re: Saving the original paintwork and trunk emblem - 1951 200 barn findand
|
||||
---|---|---|---|---|
Webmaster
![]() ![]() ![]() |
A different vehicle, but same idea and location:
![]()
Posted on: 2019/4/25 10:21
|
|||
-BigKev
1954 Packard Clipper Deluxe Touring Sedan -> Registry | Project Blog 1937 Packard 115-C Convertible Coupe -> Registry | Project Blog |
||||
|
Re: Saving the original paintwork and trunk emblem - 1951 200 barn findand
|
||||
---|---|---|---|---|
Webmaster
![]() ![]() ![]() |
Also, if you look at my project block, I cover removing the rear brakes. My car is essentially the same as yours.
Posted on: 2019/4/25 10:22
|
|||
-BigKev
1954 Packard Clipper Deluxe Touring Sedan -> Registry | Project Blog 1937 Packard 115-C Convertible Coupe -> Registry | Project Blog |
||||
|
Re: Saving the original paintwork and trunk emblem - 1951 200 barn findand
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Kev, I can't thank you enough- been driving me crazy all night - gonna
See if I can make a lil progress before I have to leave for work Because last night was far from Rewarding
Posted on: 2019/4/25 10:38
|
|||
1951 200 Deluxe Sedan Valiant Green Metallic
Vehicle #:2462 8372 |
||||
|
Re: Saving the original paintwork and trunk emblem - 1951 200 barn findand
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
@BigKev - would you happen to recall the page number or month/year you the rear brakes appear in your thread?
I've been searching through but haven't come Across it yet but, while doing so I found a link you posted for Light bulbs to be used after a 12v conversion - the link was dead and I'm wondering if you recall where the link led to? I am soon doing a 12v conversion and this would help a bunch, thanks!
Posted on: 2019/4/25 15:14
|
|||
1951 200 Deluxe Sedan Valiant Green Metallic
Vehicle #:2462 8372 |
||||
|
Re: Saving the original paintwork and trunk emblem - 1951 200 barn findand
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Are there really good reasons to convert to 12v? I did it once and regretted it so be sure to really research it. As for bulbs, a Google search will pull up lots of sources,
Posted on: 2019/4/25 16:20
|
|||
|
Re: Saving the original paintwork and trunk emblem - 1951 200 barn findand
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
IMO the only valid reason for a conversion to 12 volt is the addition of aftermarket AC.
Posted on: 2019/4/25 17:15
|
|||
|
Re: Saving the original paintwork and trunk emblem - 1951 200 barn findand
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
1. can use a new universal wiring harness to rewire all that old wiring.
2. alternator 3. trips to autozone are much easier 4. modern headlights that put out WAY more light 5. modern electronics for the spark tons of reasons to convert to 12v. I LOVE that my 37 is on 12v. this is obviously not going to be a concours car (even saying that I went to one with the 12v conversion and got 2nd place).
Posted on: 2019/4/25 17:21
|
|||
1937 Packard 138-CD Deluxe Touring Limousine
Maroon/Black 1090-1021 [url=https://packardinfo.com/xoops/html/modules/registry/View.php?ID=232]1955 Packard |
||||
|