Re: Message from the National Packard Museum in Warren, Ohio
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Quote:
? No "weights in the trunk." Why would I want to do that? And why wouldn't the Torsion-Level suspension on a virtually new car negate the weights?? No "soft torsion bars"... again the car at the time it was photographed had less than 1,000 miles so how would the torsion bars have gone soft? low mileage has little to do with 4600 + pounds sitting on suspension for 20+ give or take years. Body to frame bushings can also get compressed over time.
Posted on: 2020/5/12 10:33
|
|||
|
Re: Message from the National Packard Museum in Warren, Ohio
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Quote:
As a former lead engineer for a major car corporation and a longtime member of SAE, I guess I wouldn't know such a thing. Should I mention that I actually DROVE this car WHEN the photos were taken? Should I mention that I took the photo (with my camera on a timer and tripod)? Should I mention that I met Bill Allison decades ago and talked with him several times and actually rode in his torsion-bar cyclecar at the Packard Proving Ground in 1973? Should I mention that I've designed advanced electro-rheological automotive suspensions? Should I mention that I was chief instructor for North America for steerable rear automotive suspensions? Should I mention that I've participated in road and pavement designs and their effects on automotive suspensions? Should I mention that the Beverly Hills residential street where I took this photo has a nice arc crown in the pavement for water drainage (meaning that the curb side is lower than the street side) and thus a rear axle would be on a slant with the driver's side most compressed? Nah. But I detest arguing. Especially when there is nothing to argue about except opinions of those were not even there! This is my last response on the suspension position on this car in this photo. So have at it.
Posted on: 2020/5/12 11:25
|
|||
|
Re: Message from the National Packard Museum in Warren, Ohio
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Didn't mean to question your integrity.
I did enjoy all the accolades you listed. You are a plethora of knowledge. But wouldn't the weight of the car eventually compress the rubber body mounts causing the body to be lower than from the factory? Even with such low mileage? I don't think my comment was out of order.
Posted on: 2020/5/12 16:05
|
|||
|
Re: Message from the National Packard Museum in Warren, Ohio
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
The photographic record shows those cars sitting at a variety of ride heights when new. I am surprised they all haven't sagged over the years which shows Packard was using some pretty good metallurgy at the time. As well, the convertible chassis is subject to sag especially with the top down.
In the lab they load vehicles all the time. They put thermocouples on them and study how fast the springs are destroyed. The old Chevy station wagons were notorious for sagging springs. One guy I knew put engines in the back of one and when he unloaded it the springs had lost temper and were permanently collapsed. The bottom line is the old timers were right in storing cars on jack stands, if only to prevent flat spots on the tires.
Posted on: 2020/5/13 8:02
|
|||
|
Re: Message from the National Packard Museum in Warren, Ohio
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Quote:
... I don't think my comment was out of order. Don (portlandon), no, yours wasn't. ![]() And with that, back to the roots. ------------------------------------------------ Here is a message recently received from the National Packard Museum in Warren, Ohio [Craig (ECAnthony)]. Covid Donor Letter.pdf Covid special mailing piece.pdf
Posted on: 2020/5/13 13:27
|
|||
The story of ZIS-110, ZIS-115, ZIL-111 & Chaika GAZ-13 on www.guscha.de
|
||||
|
Re: Message from the National Packard Museum in Warren, Ohio
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
Seems like only one part of the message from the opening post caught our attention, the Jean Peters car. The dire straights and possible financial collapse of the Warren Museum has gone without comment here and I think that was the primary message. It's a horribly difficult time for an institution to be asking for funds, but it would also be horrible to see the Packard museum lost to us.
Posted on: 2020/5/14 9:15
|
|||
|
Re: Message from the National Packard Museum in Warren, Ohio
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
This is true. We just lost the World of Speed Museum here in Wilsonville, Oregon. Museums were hurting before the Covid. Now I'm sure it will take out many of them.
Posted on: 2020/5/14 14:04
|
|||
|
Re: Message from the National Packard Museum in Warren, Ohio
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
All of this stuff is heading down the toilet. My rule of thumb has been I wouldn't pay more than I would for a new car. Suddenly I see a restored 29 Packard reduced to less than the cost of a new Jeep.
There is some humor in this turmoil however. For example, I had some cash lying around and put it into a 3-5 year duration investment grade bond fund. Well, those rocket scientists have managed to do the impossible and it loses money. The only way you can lose money under the mattress is if you are running a Ponzi scheme. Unfortunately for these car clubs and museums when I croak it's going to the ASPCA and to Planned Parenthood.
Posted on: 2020/5/15 8:04
|
|||
|
Re: Message from the National Packard Museum in Warren, Ohio
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
It is possible to use a credit card or a debit card to donate to the museum. You could also purchase something from the museum store that would give them some cash. FYI
https://packardmuseum.org/products/museum-donation
Posted on: 2020/5/15 20:33
|
|||
|