|
Re: Points Removal Question
|
||||
|---|---|---|---|---|
|
Home away from home
 
|
Frank1951,
To my recollection, there are only 2 screws holding the points in place; 1 is an adjustment screw and the other is on the outer end of the 'points plate'. Once both screws are removed they just lift out easily. Chris
Posted on: 2020/8/20 18:50
|
|||
|
'If you think you can, or you think you can't - you're right!' Henry Ford.
1939 Packard Six, Model 1700 |
||||
|
||||
|
Re: Points Removal Question
|
||||
|---|---|---|---|---|
|
Forum Ambassador
 
|
Based on my recollection of the slightly later AutoLite units, the adjustment screw turns in an eccentric to facilitate gap adjustment but is itself not removed to change points.
Posted on: 2020/8/20 20:52
|
|||
|
||||
|
Re: Points Removal Question
|
||||
|---|---|---|---|---|
|
Home away from home
|
That is correct. One doesn't remove the eccentric adjuster so only the single screw holding the assembly in place needs to be removed.
Posted on: 2020/8/21 2:02
|
|||
|
||||
|
Re: Points Removal Question
|
||||
|---|---|---|---|---|
|
Home away from home
|
Just went through that with my 48 - The hold down screw is removable , but the adjustment screw is not removable - BTW , anyone know the size of the screw that holds the condenser in place ?
Posted on: 2020/8/21 21:57
|
|||
|
||||
