Re: KPack's 1954 Panama
|
||||
---|---|---|---|---|
Home away from home
|
No, nothing on the hood sides. The wedges were only on the fenders.
As for the engine removal, I have always found it easier to remove the engine and transmission as an assembly as disconnecting the torque converter from the flex plate white it's in the car is very difficult.
Posted on: 12/22 3:41
|
|||
|
Re: KPack's 1954 Panama
|
||||
---|---|---|---|---|
Webmaster
|
Yes, sorry, wedge ones are on the fenders. The side holes are empty. Not sure what their epurpose was.
Posted on: 12/22 8:10
|
|||
-BigKev
1954 Packard Clipper Deluxe Touring Sedan -> Registry | Project Blog 1937 Packard 115-C Convertible Coupe -> Registry | Project Blog |
||||
|
Re: KPack's 1954 Panama
|
||||
---|---|---|---|---|
Home away from home
|
We're completely gutting the interior of the Panama today. I'm removing all the trim to repaint it all. We almost have the dash out, but ran into some unknowns.
Everything is loose and ready to come out, but this center nut is just spinning the bolt. This is the bracket supporting the steering column. Also not sure how to get the steering column surround off. I know I need to disconnect the wiper cable at the wiper motor, but can't figure out how the rest of the column is supposed to come off. What an I missing here? Kevin
Posted on: 1/1 15:14
|
|||
|
Re: KPack's 1954 Panama
|
||||
---|---|---|---|---|
Home away from home
|
Undo the shift linkage from the lever in the engine compartment. Loosen the clamp that holds the column to the steering gear. Remove your floor plate and unscrew the rubber collar where it passes through the firewall. Remove the bottom clamp at the edge of the dashboard. Yank. And turn.
Then you can deal with the rusty bolt that retains the upper half of the column clamp to the dash.
Posted on: 1/1 15:31
|
|||
|
Re: KPack's 1954 Panama
|
||||
---|---|---|---|---|
Forum Ambassador
|
There is also a concave ring around the steering shaft that forms the inner race for the bearing. It can be tight to the shaft and could be giving resistance. If you remove it before trying to pull the shroud and column it may help.
The rusty bolt may need a nut splitter if repeated soaks with penetrating fluid has not allowed it to loosen. Amazon has some offset types that should be able to get to it.
Posted on: 1/1 15:54
|
|||
Howard
|
||||
|
Re: KPack's 1954 Panama
|
||||
---|---|---|---|---|
Home away from home
|
Thanks Ross and Howard. With your help I was able to get it out. The weird brake system the previous guy installed made it more difficult than it needed to be.
The last bolt on the brace was seized and stripped after much effort. So I drilled it out. I'll need to replace it. Carnage: Lots of work to do now
Posted on: 1/1 18:47
|
|||
|
Re: KPack's 1954 Panama
|
||||
---|---|---|---|---|
Home away from home
|
And for your viewing pleasure, I put together a video of everything from start to finish. Hopefully this helps some other newbs as they try to tackle their projects. I figure one way I can help promote Packard automobiles is to help put a presence on YouTube. That's my go-to place for technical how-to and there is very little Packard content. Thankfully we have some good videos by Ross, BigKev, and HPH, as well as some older ones from Wes. Hopefully I can contribute some to that.
Posted on: 1/2 20:14
|
|||
|
Re: KPack's 1954 Panama
|
||||
---|---|---|---|---|
Home away from home
|
Mission creep. I'm finding it hard to keep the list of projects from slowly exploding. With the dash out, I can clearly see all the wiring and I think "why not replace the whole wiring harness while I'm in here?". Then I look at the windlace I need to install and think "why not paint the door jambs to match the body color while I'm in here?". Then I think "why not just go ahead and paint the whole car the correct Ivory Blue?". Spiraling out of control.
I'm trying to keep myself in check. Currently working through everything I've removed and am prepping things for paint. Still need to get a bunch of supplies. -Kevin
Posted on: 1/3 19:25
|
|||
|
Re: KPack's 1954 Panama
|
||||
---|---|---|---|---|
Forum Ambassador
|
Such is the life of a dedicated old car person. It starts with the items you mentioned and then it goes something like "that new such and such looks so good but now the item next to it that used to look in really good shape now looks like crap so it needs to be done". From there it goes "if that is done it makes something else --- etc, etc, etc" and it doesn't end until the car is completely redone or the significant other has put the foot down because the wallet was empty, budget was blown, and you were caught thinking out loud how to mortgage the firstborn.
Posted on: 1/3 21:48
|
|||
Howard
|
||||
|