Packard Forum Index » Post-War (1946-54)

Quote:
I presume this to mean you still have your "old" pump? If that's the case, compare your old and new pumps for differences. Photos of both will likely assist in gaining helpful advice.

On 56.s I've seen 1/4. Inch spacers


Measure the bolt. From under the head to end. .
That's the length.

Also. I've seen some thick. Hard. Gaskets. For fuel pumps

The arm should move..

But turn the engine over till your off the high side.

.but make sure that. Pump arm moves. Before putting it in.

Never should have spacers and if needed, then something else is wrong.