Re: 1928 Head gasket nut torque
|
||||
---|---|---|---|---|
Home away from home
|
Is there a flange you can pry on a bit?
Worst case you can tap between the head and block with a chisel but I would NOT do this until you wait for more opinions to spill in...
Posted on: 9/24 14:33
|
|||
1955 400 | Registry | Project Blog
1955 Clipper Deluxe | Registry | Project Blog 1955 Clipper Super Panama | Registry |
||||
|
Re: 1928 Head gasket nut torque
|
||||
---|---|---|---|---|
Home away from home
|
No flanges that we could see. The owners manual indicates a head lifter tool, maybe?
Posted on: 9/24 14:43
|
|||
|
Re: 1928 Head gasket nut torque
|
||||
---|---|---|---|---|
Forum Ambassador
|
With all the fasteners removed but the spark plugs still in, you might just crank the starter motor a few times. On rare occasions the compression pressure is enough to free it up. But it's a LONG SHOT. More likely you'll have to start working your way around the perimeter of the head inserting something like a THIN putty or spackle knife preferably between the outer layers of the headgasket, tapping it in gently to produce a little upward force, and then moving stepwise around the perimeter of the head. Be careful, and patient!!, you don't want to cause any damage to either the head or the block surfaces. Once the head breaks free, you can use several wood wedges to gradually raise it up high enough to get a firm grip on it and remove it. You may want to have a helper handy to assist with the lifting.
Posted on: 9/24 14:43
|
|||
|
Re: 1928 Head gasket nut torque
|
||||
---|---|---|---|---|
Home away from home
|
Owen:
Do you think using my air compressor in one of the plug ports (at 120PSI), while the others are still in the head, would do any damage? I have about 80% on both sides of the gasket removed (about 3/16") but need another 3/16" before i get to the studs. Nothing removed from the very back nor front of the head. Thanks, Gar
Posted on: Yesterday 17:21
|
|||
|
Re: 1928 Head gasket nut torque
|
||||
---|---|---|---|---|
Home away from home
|
For what it is worth.....
Years ago I broke loose the head on my 326 engine with this trick my father taught me 70 years ago.... Cylinders come up in pairs. Pick a pair. Stuff some rope down the plug holes...equal amounts, of course... Crank the engine and the cyl head will break loose.
Posted on: Yesterday 18:12
|
|||
|
Re: 1928 Head gasket nut torque
|
||||
---|---|---|---|---|
Forum Ambassador
|
Gar, the advantage of cranking with the starter motor with all the plugs installed is that, unlike your suggestion, the forces are being applied equally along the full length of the cylinder head.
Posted on: Yesterday 21:21
|
|||
|