Hello! If you're new here, please register for a free account  
Login
Username:

Password:

Remember me



Lost Password?

Register now!
FAQ's
Main Menu
Recent Forum Topics
Who is Online
23 user(s) are online (17 user(s) are browsing Packard Forums)

Members: 1
Guests: 22

BigKev, more...







1942 tune-up issue
#1
Quite a regular
Quite a regular


See User information
My '42 is not running properly. I have installed a new carb kit but still have the same problem with when I step on the gas pedal hard the engine will just die. Is this normal? Trying to find out more of what is going on, I put a tach on it and I find that rather than the pointer relatively stable, it is bouncing around! Thus thought I would install new points. No change for anything I have done thus far! Nobody wants these days to work on an old auto like mine. Thus I am trying to troubleshoot myself. I am wondering what perhaps is causing the tach to fluctuate so much. And ides from you experts?? Lee

Posted on: 2020/8/4 15:20
 Top  Print  Twitter  Facebook  Google Plus  Linkedin  Del.icio.us  Digg  Reddit  Mr. Wong 


Re: 1942 tune-up issue
#2
Home away from home
Home away from home


See User information
You are right- Nobody will work on mine either -

Posted on: 2020/8/4 16:59
 Top  Print  Twitter  Facebook  Google Plus  Linkedin  Del.icio.us  Digg  Reddit  Mr. Wong 


Re: 1942 tune-up issue
#3
Home away from home
Home away from home


See User information
Usually a bad accelerator pump in the carb will cause a "bog" when the pedal is pressed down suddenly. Not sure this is your problem though.

Posted on: 2020/8/4 18:21
 Top  Print  Twitter  Facebook  Google Plus  Linkedin  Del.icio.us  Digg  Reddit  Mr. Wong 


Re: 1942 tune-up issue
#4
Home away from home
Home away from home


See User information
You may want to check out fuel pump pressure and output. Make sure fuel filter is not restricted. Check the condition of the flex hose from the hard line to the pump. Following up on ptv's suggestion, check that the accelerator pump is working by squirting a stream of gas. If all of this checks out then you can turn you attention to the ignition system.

Posted on: 2020/8/5 9:37
Packards Owned -
37
 Top  Print  Twitter  Facebook  Google Plus  Linkedin  Del.icio.us  Digg  Reddit  Mr. Wong 


Re: 1942 tune-up issue
#5
Home away from home
Home away from home


See User information
"You are right- Nobody will work on mine either -"
Sigh...
The future is bright for a young person willing to learn!

Posted on: 2020/8/5 11:10
 Top  Print  Twitter  Facebook  Google Plus  Linkedin  Del.icio.us  Digg  Reddit  Mr. Wong 


Re: 1942 tune-up issue
#6
Just popping in
Just popping in


See User information
If the rpm is wandering on the tach, your distributor shaft/bushings may be worn and need rebuilding - changing points will not fix the problem if that is the case. Take the cap off and give the shaft a wiggle side to side. Ideally, there should be no play; if it's loose enough to visibly change the point gap, it's a problem. Assuming you've got good fuel floe to the carb, I agree that the carb accelerator pump needs to be checked if it's bogging when the gas pedal is floored.

Posted on: 2020/8/5 15:47
FJ Derosier
'37 12 Convertible Sedan
'42 180 Formal Sedan
'58 Hawk
 Top  Print  Twitter  Facebook  Google Plus  Linkedin  Del.icio.us  Digg  Reddit  Mr. Wong 


Re: 1942 tune-up issue
#7
Home away from home
Home away from home


See User information
Just look down the carb. and work the throttle linkage fast wide open. You should see gas being sprayed from the jets. If not your accelerator pump isn't working. (Engine off is fine.) If you do se gas being squirted then the accelerator is working and you will have to move on from there.

Check in the back of the "Serviceman's Training Book: Engine Diagnosis and Tune-Up" for more help.

http://www.packardinfo.com/xoops/html ... loads/EngineDiagnosis.pdf

Wes

Posted on: 2020/8/5 17:40
 Top  Print  Twitter  Facebook  Google Plus  Linkedin  Del.icio.us  Digg  Reddit  Mr. Wong 


Re: 1942 tune-up issue
#8
Home away from home
Home away from home


See User information
Hi Auto.nut,
Has the engine been compression tested recently? I only ask this as I fought with a stalling problem and it turned out that a compression test would have told me the answer. I did have a licensed mechanic go over the engine, who SAID he did a compression test and that it was 'a little low, but consistent throughout the cylinders', so I THOUGHT it was okay. (100 - 110LBS) I found out later that the guy had been the victim of sudden-onset Alzheimer's and ended up in a home shortly after he worked on my car. He either didn't do it and thought he did or confused it with another vehicle, but an engine rebuild turned out to be the fix on my car. Hope it isn't that with yours, but a compression test, wet and dry, sure tells you a lot about a motor's health, that's for sure. Good Luck nailing it down. Chris.

Posted on: 2020/8/8 11:59
'If you think you can, or you think you can't - you're right!' Henry Ford.
 Top  Print  Twitter  Facebook  Google Plus  Linkedin  Del.icio.us  Digg  Reddit  Mr. Wong 








Search
Recent Photos
1952 Packard Mayfair (12/13/2020)
1952 Packard Mayfair
1955 Caribbean - 5588 MDF 92 (11/26/2020)
1955 Caribbean - 5588 MDF 92
1950 Club Sedan (11/25/2020)
1950 Club Sedan
1950 Club Sedan (11/25/2020)
1950 Club Sedan
1955 Caribbean - 5588 MDF 92 (11/13/2020)
1955 Caribbean - 5588 MDF 92
Random Photo
IMG_1866
Website Comments or Questions?? Click Here Copyright 2006-2021, PackardInfo.com All Rights Reserved