Packard Forum Index » Project Blogs

Thanks Mal
No luck finding the on Max Merritt site
Those I found on the front brake setup. I have had no luck searching Max Merritt for those. I will try to find gasket material locally and make my own go Don’s route and contract Olsen’s gaskets
Is there someplace else they would be identified in the parts book?

Both Max and Kanter appear to have the kits for Group 12.0313 Rear Axle Seal which include gaskets. Didn't see any separate entries for only gaskets.
Link to Max Merritt
Link to Kanter
DIY gaskets would be much much cheaper and should work well.

For max.

It's best to email Fred. If you can't find it.

👍

Brakes are apart, drums have been sent out for turning.

BTV sent out for rebuilding.

will work on brake lines soon.

anyone ever put in a new fuel line with the body on the car? any tips?

rear axles have been pulled to have new bearings pressed on.

TL bushing kit ordered from Dwight.

generator pulled out and cleaned up.....is this a Chrysler Delco generator?

pulled the steering box off to clean it up and put in fresh oil and replace seals

Attach file:

---

  brake work.JPG (3,808.27 KB)


  Generator (3).JPG (3,647.06 KB)

The generator looks like a Delco which was rebuilt. I don't think the rebuilder's name on the tag has anything to do with the Chrysler Corp. The Delco generator would be appropriate for your Patrician. Chrysler products used an Autolite. Thanks for your updates.

edited...................embarrassed to say