Packard Forum Index » Pre-War (1899-1942)

need a photo of anybodies Senior series standard eight 35-36 or Super Eight showing on LHD the exhaust manifold flange and how it mates with the exhaust pipe...thank much in advance.

Exh manifold flange is square with a bolt hole in each corner. The flange is angled about 20 degrees from the horizontal to the rear as is the exh pipe of course

Sandy,

Posted some pic's, not exactly what you were after but might help, in your other thread.

A not-very-good picture of the exhaust manifold from a LHD 1934 Eight, similar to and fits later 320 engines though the fitment of the automatic choke differs, along with a few other details, e.g the carburetor mounting details; the EE-22 was a 4-bolt mounting pattern and IIRC the EE-23 was a 3-bolt.

Sorry, can't remember who reproduced this exhaust manifold, but it was profusely advertised throughout the hobby a few years back. If I run across an ad for it, I'll amend this post with that info.

Attach file:

---

  (103.02 KB)

I understand the intended application is 1937 Super 8. Therefore, Mal, would you be kind enough to take a photo, maybe with a measurement, of the area between the steering box and the exhaust manifold area on Harvey's car. Also, any comments from Harvey/Wade as to the "if/possible" usage of a LHD manifold on a RHD car would be appreciated.