Packard Forum Index » Post-War (1946-54)

I know Ross had a picture of the inside of one of these fuel tanks, but it was low resolution and hard to make things out. So I cut open my old tank that came with my '54 Panama. If I can clean it up, I intend to use it as a spare or maybe put it on Rusty McRustface (53 Clipper) if I ever get it running. My brother in law is currently experiencing issues with his new reproduction tank, so this one may end up on his car if it can be saved.

This is what a failed fuel tank liner looks like




Top is not so bad





Once I get all this cleaned up, is there anything people want specific pictures of, or measurements?

The liner looks worse than the tank itself! Was that an earlier sealing job gone bad or from the factory? Once welded back together, can it be done without the seam showing? What did you use to cut it so neatly and evenly?

Quote:

I don't think the factory did sealer internally. I have another tank (from my brother in law's '52) that is full of surface rust inside, but no sealer. It is an original tank and the car overall has had much better care than mine.

The sealer ended up pooling around the pickup tube area (not covering the intake hole), and was about 3/8" thick in some spots. Pretty bad.

For cutting I marked 3/4" above the flange all the way around, then used a cut-off disk on an angle grinder. Took maybe 90 seconds to cut the top off. I'm going to clean up as much of the undercoating as I can, then take it a place to sandblast. Then I'll weld the top back on, seal the interior, and paint the outside. I don't think I can totally hide the weld seam, but at least it will be above the flange and when mounted in the car it shouldn't be very visible.

-Kevin