Re: Rust in gas tank
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Pictures of sample from tank
Posted on: 2021/10/19 19:57
|
|||
'49 Deluxe Eight - 23rd Series
|
||||
|
Re: Rust in gas tank
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
Gas tank Renu is a relatively expensive option but since there are no repro tanks available for your car probably not a bad investment if you want to be on the safe side. They will return the tank in like new condition. If it is not too terribly bad you might also be able to have a radiator shop do a cleaning. If the tern coating has been destroyed though that would be a short term fix as the rust would probably come back. Draining the tank and adding fresh gas along with a large filter in the line just outside the tank might also be a good move if it is only small rust particles.
On getting the rust already in the system out, there is a screen in the fuel pump that might have a good coating of rust so you might want to clean it. Depending on your pump you may need to make or find a new bowl gasket and possibly a fiber washer for the attaching bolt before you remove the bottom bowl to access the screen. If you have the optional fuel filter before the carb, that should have captured most if not all the rust that got past the fuel pump and should be changed. Some carbs have another small screen in a capped chamber just after the fuel inlet port.
Posted on: 2021/10/19 20:22
|
|||
Howard
|
||||
|
Re: Rust in gas tank
|
||||
---|---|---|---|---|
Webmaster
![]() ![]() ![]() |
Gas Tank Renu is worth every penny and when my was done, it had a lifetime warranty.
They media blast the tank inside and out, then epoxy coat the tank inside and out and then bake it on. Way more durable than the "pour" in style sealers.
Posted on: 2021/10/19 20:40
|
|||
-BigKev
1954 Packard Clipper Deluxe Touring Sedan -> Registry | Project Blog 1937 Packard 115-C Convertible Coupe -> Registry | Project Blog |
||||
|
Re: Rust in gas tank
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
I had my '49 tank done by a Renu guy in WVA and he did a poor job. So check out the places work before you commit. It was about $400 back then, 6-7 years ago. It's still sitting in the loft.
Best to go to a radiator shop and have them split in two, and clean/repair the inside then solder/weld it back together. They were pinch roll welded back then. Since I'm building custom, I bought a new tank, and will use that if I ever bet back on this project. The new tanks use a silicone steel that resists rust better than the old steel. You'll need to flush the line(might be bad and needs replaced too) and the carb if no inline filter. Should be a fuel bowl on it that should catch particulate. If none, then carb has to be pulled and cleaned. I'd put one on it for next time.
Posted on: 2021/10/19 20:52
|
|||
|
Re: Rust in gas tank
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
Quote:
They will return the tank in like new condition. Not quite like new as they cut the tank open to sand blast it inside, then weld the hole shut again. If there is a whistle in the breather, it will likely not work when done as the sealer plugs it. Taking it apart at the seam is a far better option if you can find someone to do it!
Posted on: 2021/10/19 23:41
|
|||
|
Re: Rust in gas tank
|
||||
---|---|---|---|---|
Just can't stay away
![]() ![]() ![]() |
on my clipper i have got the same problem. i removed the tank and filled it with 50 very sharp edged and pointed wood screws, then shook the tank extensively. removed all 50 screws. rinsed with water, then put rust converter in the tank. then rinsed again extensively with water. after drying, reinstalled and put back into use with a large petrol filter.i did not use any seal or paint. because i have no confidence that it will distribute evenly in the tank. i change the filter once a month. this has been working for 2 years now. the filters are very inexpensive and can be hidden well. everything looks original.
BR Josef
Posted on: 2021/10/23 14:35
|
|||
Packard Super Clipper 1947
![]() |
||||
|
Re: Rust in gas tank
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
I used the cleaner and sealer products from Hirsch many decades ago and when I recently drained the tank, the petrol still smelled like it should and was clean! It was not too flammable, of course, due its age but the sealer did its job.
Of course, it was a 1954 without the whistle. You didn’t say what year you were working on, if it’s the 1949 that your profile shows, it does have the whistle so care will be needed.
Posted on: 2021/10/23 18:49
|
|||
|