Re: Rescued
|
||||
---|---|---|---|---|
Home away from home
|
Congratulations. I'm sure we would all like to see some photos and hear the story as you progress.
Posted on: 2022/12/29 20:49
|
|||
|
Re: Rescued
|
||||
---|---|---|---|---|
Not too shy to talk
|
The challenge ahead
Posted on: 2022/12/29 22:11
|
|||
|
Re: Rescued
|
||||
---|---|---|---|---|
Not too shy to talk
|
It needs a lot. I feel very comfortable with the engine work. What I am curious about is what is the proper protocol for bringing ultramatic back to life.
Posted on: 2022/12/29 22:16
|
|||
|
Re: Rescued
|
||||
---|---|---|---|---|
Home away from home
|
Apparently there's a good chance some seal will fail from being dry after so long on the trans if you just fire it right up. I would drop it same time you're working on the engine and do a rebuild kit. Others I'm sure can give more precise advice.kanter.com/p-35861-ultramatic-rebuilding-kit-1951-1954-transmission.html
Watch Ross's videos on trans disassembly here, should be pretty similar to yoursyoutube.com/@speedwellgarage8588 What's nice is you have a convertible and they hold value pretty well, spending a few grand on parts to get it going good is a no brainer. On the HT/sedans there is more of a monetary concern. As I hear those engines are quite nice to work on, even after 40 years I think you'll be able to get it going again if you're careful about things as I'm sure you will be. As others have said, pics/updates are greatly appreciated!
Posted on: 2022/12/29 22:38
|
|||
1955 400 | Registry | Project Blog
1955 Clipper Deluxe | Registry | Project Blog 1955 Clipper Super Panama | Registry |
||||
|
Re: Rescued
|
||||
---|---|---|---|---|
Home away from home
|
I'm guessing it was a running car at the time it was painted, and with the good dry storage you will not have too much trouble getting the engine fired up.
Before you fire, check the fluid level of the trans--left front corner of the case, and very awkward. As long as there is something showing on the stick you are OK to start. After it has run a bit the convertor will refill and I can guarantee you will need to add some Type F ATF to bring it up to level. It would not be a bad idea to have the trans in N and the rear wheels up so it can spin along with engine and let the fluid find its way into all the bushings. After that, you will just have to drive it and see what happens. Seals are readily available if needed. Of course, if you need to yank the engine, bring the trans out with it and do a reseal job.
Posted on: 2022/12/30 8:17
|
|||
|
Re: Rescued
|
||||
---|---|---|---|---|
Home away from home
|
Should be worth in the 6 figure neighborhood according to the guides once it's done, so good rescue. If the paint isn't cracked, lifting, rust through or anything, may dodge that bullet with a clean, polish, and wax.
Posted on: 2022/12/30 14:25
|
|||
|
Re: Rescued
|
||||
---|---|---|---|---|
Not too shy to talk
|
Ross, thanks! That was exactly the advice I was looking for.
Posted on: 2022/12/30 15:13
|
|||
|
Re: Rescued
|
||||
---|---|---|---|---|
Home away from home
|
Good for you. What a fun project!
Posted on: 2022/12/30 19:10
|
|||
|
Re: Rescued
|
||||
---|---|---|---|---|
Home away from home
|
First, congratulations on your New Year's Score. It would look good at my house, too. Like Wat needs another freaking project.
If you need autotrans parts, Wat has a '54 limo which he wants the engine from, and the trans will be surplus. Just sayin'. I doubt that mine is any better as it likely has sat longer and in worse conditions, but it should be unmolested. The Safe While It's Still Under The Car theory. Please keep us posted. I'd like to see this. Come to think of it, Wat also has a '51 9-main 327 engine which is likely never going to get used here, either. Keep it in mind if you need stuff.
Posted on: 2023/1/2 7:15
|
|||
If you're not having fun, maybe it's your own damned fault.
|
||||
|