|
Re: install accelerator cross shaft retracting spring 1937 115
|
||||
|---|---|---|---|---|
|
Webmaster
 
|
I don't have an answer for you, but that assemble is the same as 120's as well.
Posted on: 9/26 16:05
|
|||
|
-BigKev
1954 Packard Clipper Deluxe Touring Sedan -> Registry | Project Blog 1937 Packard 115-C Convertible Coupe -> Registry | Project Blog |
||||
|
||||
|
Re: install accelerator cross shaft retracting spring 1937 115
|
||||
|---|---|---|---|---|
|
Forum Ambassador
 
|
G'day Dan R,
Although a PackardInfo member for some time(2019) your first post, so  to PackardInfo.I invite you to include your 37 115C in PackardInfo's Packard Vehicle Registry.
Posted on: 9/26 16:49
|
|||
|
Mal
/o[]o\ ====  Bowral, Southern Highlands of NSW, Australia "Out of chaos comes order" - Nietzsche. 1938 Eight Touring Sedan - SOLD 1941 One-Twenty Club Coupe - SOLD 1948 Super Eight Limo, chassis RHD - SOLD 1950 Eight Touring Sedan - SOLD What's this?  Put your Packard in the Packard Vehicle Registry! Here's how! Any questions - PM or email me at ozstatman@gmail.com |
||||
|
||||
|
Re: install accelerator cross shaft retracting spring 1937 115
|
||||
|---|---|---|---|---|
|
Webmaster
|
Bobs37 would have had his apart the most recently, so I sent him a PM to see if he can assist.
Posted on: 9/27 9:09
|
|||
|
-BigKev
1954 Packard Clipper Deluxe Touring Sedan -> Registry | Project Blog 1937 Packard 115-C Convertible Coupe -> Registry | Project Blog |
||||
|
||||
|
Re: install accelerator cross shaft retracting spring 1937 115
|
||||
|---|---|---|---|---|
|
Home away from home
 
|
It was a few years ago I did this, but I took the series of photos that may assist.
I cannot remember if the spring was loaded under tension or not. I am sorry, but the assembly I believe does require the alignment of the end spring hook to align with the rods drill hole to enable the cotter pin to be inserted. Bob J. Attach file:  Accelerator Linkage 1.JPG (2,071.77 KB) Accelerator Linkage 2.JPG (1,967.30 KB) Accelerator Linkage 3.JPG (1,674.86 KB) Accelerator Linkage 4.JPG (1,339.59 KB) Accelerator Linkage 6.JPG (1,477.97 KB)
Posted on: 10/4 21:02
|
|||
|
||||
|
Re: install accelerator cross shaft retracting spring 1937 115
|
||||
|---|---|---|---|---|
|
Webmaster
|
Thanks Bob for helping out!
Posted on: 10/4 21:47
|
|||
|
-BigKev
1954 Packard Clipper Deluxe Touring Sedan -> Registry | Project Blog 1937 Packard 115-C Convertible Coupe -> Registry | Project Blog |
||||
|
||||
