Cylinder Head
|
||||
---|---|---|---|---|
Just popping in
![]() ![]() ![]() |
Will a Packard Aluminum Head off a 359 fit on a 327?
Posted on: 1/18 15:40
|
|||
|
Re: Cylinder Head
|
||||
---|---|---|---|---|
Forum Ambassador
![]() ![]() ![]() |
G'day mwtnitro,
First up, your first post, so ![]() Second, I believe 359 heads fit 327's/288's and vice versa. However check for straightness and integrity. Third, I invite you to include your Packard in PackardInfo's Packard Vehicle Registry.
Posted on: 1/18 16:25
|
|||
Mal
/o[]o\ ==== ![]() Bowral, Southern Highlands of NSW, Australia "Out of chaos comes order" - Nietzsche. 1938 Eight Touring Sedan - SOLD 1941 One-Twenty Club Coupe - SOLD 1948 Super Eight Limo, chassis RHD - SOLD 1950 Eight Touring Sedan - SOLD What's this? ![]() Put your Packard in the Packard Vehicle Registry! Here's how! Any questions - PM or email me at ozstatman@gmail.com |
||||
|
Re: Cylinder Head
|
||||
---|---|---|---|---|
Home away from home
![]() ![]() ![]() |
I can think of nothing gained by putting a 359 head onto a 327 or other engine. Yes, the bolt pattern is the same but the 359 head is considerably thicker so it's not a straight-across swap. All the studs would need to be removed and replaced with the 359 type.
Posted on: 1/18 19:47
|
|||
|
Re: Cylinder Head
|
||||
---|---|---|---|---|
Just popping in
![]() ![]() ![]() |
OK Thanks
Posted on: 1/19 9:18
|
|||
|