Packard Forum Index » Pre-War (1899-1942)

Packard 1941 110 6 cal: I removed engine pan, radiator and water pump 30 years ago - now I am reassembling using the stored parts. All going well however I have 3 parts left over. Two are apparently spacers 3/4" did, 1/4 " thick with 5/16 hole. They appear to have been in engine( no rust). The third part is a 1/4 inch ID. copper gasket.

I would appreciate help in determining where the parts should be installed - or , if they are , simply not from the 110.

Thank you,
Gene Johnson

Attach file:

---

  Packard 110 spacer?.jpg (3,272.92 KB)

G'day Gene110,
to PackardInfo, but sorry I can't help identify the parts.

Howver, I invite you to include your '41 110 in PackardInfo's Packard Vehicle Registry

I don't recall any parts like that from the pan and the only copper washer was on the drain plug and should not be reused anyway.

Quote:

Jogged my memory, I think correct me if I'm wrong, weren't there copper washers on at least some of the water pump bolts?

Yes, on the waterpump, also I think on valve cover bolts.

spacers at generator mounting?

Yes but I thought we were talking about the oil pan.

Thank you. I will register. Gene

Thank you all for the quick responses. The id of the washer is too small for the water pump screws. After reading the responses I am thinking the washer and the spacers are from another project. Thanks to all. Gene

Thank you all for the quick responses. The id of the washer is too small for the water pump screws. After reading the responses I am thinking the washer and the spacers are from another project. Thanks to all. Gene. ps did not remove generator. g