1933-36 (10th->14th Series) - LUBRICATION
|
SC = Service Counselor | SL = Service Letter | STB = Service Technical Bulletin | SSB = Studebaker Service Bulletin |
Subject | Application | Document |
Air Cleaners, Oil Bath oil-fouled spark plugs - overfilled cleaner | (not specified) | |
Air Cleaners, Oil Bath seasonal oil selection | (not specified) | |
Car Storage winter - precautions, conditions | (all models) | |
Car Storage, Sticky Valves and running motors, internal rust - cylinder oiling, battery removal/charging | (all models) | |
Chassis Lubricator Oil Lubricator System, discontinued - use SAE-50 engine oil | 236-43 3rd-14th | |
Chassis Lubricator Service Kit new special tool - pump/gauge, annual check-up | 236-43 3rd-11th | |
Chassis Lubricator Tanks oil consumption, excess lubrication - reduced damper connection | 236-43 3rd-10th | |
Clutch Shifter Bearing Lubricator chassis lubricator, improved delivery - smaller drip plug | 11th | |
Crankcase Sludge reduced driving, condensation, bearing trouble - operating temperatures, oil changes | (all models) | |
Differential Oil Change thickening, fall service - sample letter | (not specified) | |
Door Hinges, New bushing lubrication - hinge pin now drilled/tapped for cap screw | 11th | |
Drip Plugs, Lubrication chassis lubricator - part reference | 236-43 3rd-10th | |
Drip Plugs, Lubrication chassis lubricator - part reference | 236-43 3rd-14th | |
Drip Plugs, Lubrication chassis lubricator - part reference | 236-43 3rd-12th | |
Engine Oil For Sub-Zero Operation, Winter new 5-W oil - issues, limited availability/use | (all models) | STB 49T-40 (Zones only) |
Graphite Lubrication Gun new special tool - door locks, window channels, etc. | (all models) | |
Hypoid Gear Lubrication special lubricant - recommended service | (not specified) | |
Hypoid Gear Lubrication, Tell Your Customers About reiterated - suggested customer letter | (not specified) | |
Lubricants, Winter hard starting - lighter motor oil | (not specified) | |
Lubrication Fittings production change - high pressure Alemite fittings | 11th | |
Lubrication Location - Generator-Starter-Distributor reference chart - by model | 9th-14th 120-120B | |
Lubrication Wall Charts correct lubrication, illustrated - price reduction | (not specified) | |
Lubropack Rear Springs complete lubrication procedure - Lubropack compound | 12th-14th 120-120B | |
Motor Oil Recommendation, New hard/no starting - additional weights, table | (all models) | |
Oil Additives, Use Of not endorsed - low viscosity, inadequate lubrication | (all models) | |
Oil Seals, Leather dry installation damage - soak in engine oil | (all models) | |
Oils, Graphited no cost/benefit advantage | (all models) | |
Rear Axle Bearing Lubricator (Sleeve) new special tool - eliminates dust retainer removal | 1001-2-3-4 | |
Rear Axle Lubricant production fill, break-in properties | (not specified) | |
Rear Axle Oil Change cold weather, oil channeling - fall change reiterated | (not specified) | |
Rear Axle Shaft Bearing Lubricator Sleeve new special tool - additional applications | 626-40-45 726-40-45 826-40-45 9th 1005-6 1106-7 | |
Steering and Transmission Lubrication unusually low temperatures - seasonal weight change | (not specified) | |
Steering Gear Lubricants heavy base no longer needed - use rear axle oil | (all models) | |
Steering Knuckle Lubrication sealed ball bearings - recommended lubrication | 10th | |
Transmission Lubricants clutch spin - summer/winter weights | (not specified) | |
Transmission Lubricants hot weather, heavier oil - improved synchronizer operation | 9th-10th | |
Transmission Lubricants warm weather, bearing noise - new Kendall 400 oil | (not specified) | |
Universal Joint Lubrication recommended interval - additional sliding spline service | (not specified) | |
Universal Joint, New Spicer Needle Bearing type - construction, lubrication | 10th-11th | |
Universal Joints lubrication procedure - cautions | 10th |
SC = Service Counselor | SL = Service Letter | STB = Service Technical Bulletin | SSB = Studebaker Service Bulletin |
NOTE: These PDFs were created from High Quality Scans. It is recommended that you Right Click on the link(s) above and do a "Save Target As". This will download the PDF to your machine rather than trying to open and view it over the web.
Disclosures & Disclaimers
Though previously published elsewhere, this work is provided with my full permission for display on the PackardInfo.com website and the personal use of visitors to that site. Any other unauthorized use, however, is expressly prohibited and may be subject to prosecution.
Also, because this index was compiled from documents published by the factory, neither the author nor PackardInfo.com are responsible for errors in content arising from source information.