Packard Forum Index » Project Blogs

Quote:

I followed the Service Counselor notes, and separately grounded the two outside terminals in the box....orange and blue. I will note that the pink connector is super loose inside the terminal. It barely stays in at all. I'll see if I can find a way to make all of them tighter.

I'll check to see if power is present at those locations. I did not check the torsion bar links, but will do that this evening when the car is back in the air. Also did not check the bushings yet.

-Kevin

The under seat heater was never part of the seat frame. It bolted to the floor under the seat but its connectors were under the car so any loose clamps would just leak to the ground rather than inside the car. Of course, a bad core could leak inside but my guess (and as already point out) is that the heater control valve inside the firewall under the right side of the dash is where the coolant is coming from.

Regardless of where it’s coming from, you need to get the carpet and padding underneath dried out as soon as possible before it starts to mold. I just went through this on a newer car and it wasn’t pleasant after I let it go too long!

Weird....I was just looking at a Mojave Tan 400 in Pennsylvania and was going to pull the trigger. I called the guy and he said it sold that morning. I guess it wasn't mean for me. I wonder if the car went to a genuine enthusiast or someone who saw an opportunity to flip. Good luck on your Mojave Tan 400. It looks awesome.

Mark

Kevin,
for including your '56 Four Hundred Hardtop Coupe in the Registry.

Don - the seat frame question was in regards to the lower seat cushion. The lower seat cushion on my '54 Panama is integrated with the frame, so to remove the cushion means to remove the entire seat from the car. I haven't looked closely at the 400, but if it just pops up and out that would be great. I was in a rush last night going through things to try and make a list of priorities, didn't have time to do much more than a cursory glance at everything. Hope to have some time this weekend to dig in.

Mark - The Mojave Tan color is definitely growing on me. Initially I was always drawn to the Scottish Heather or the like, but the more I look at the Mojave Tan the more I like it. Especially the interior colors. Hope you find a good one.

Mal - You're welcome!

I was talking about the rear seat heater but I must have misread as I thought it was suggested that it was part of the seat. Either way, the seat and rails have to come out in order to mitigate the water issue.

As far as the cushion being integral with the frame, it is separate on both of my 1954 Patricians.