1922-32 (1st->9th Series) - SUSPENSION & STEERING
|
| Subject | Application | Document |
Ball Joint - Adjustment Change | (not specified) | |
Bijur Chassis Lubricating Tank Inspecting, Checking | (not specified) | |
Bijur Lubricator Tanks - Recommend Oil Information | (not specified) | |
Chassis - Lubricator Tanks Excess oil in city driving | (Not Specified) | |
Chassis Lubricator - Dampers and Breather Pointers and Updates | (not specified) | |
Cylinder Head and Shock Absorber Wrench Special Tool ST-797 | 826-840 | |
Directing Acting Shocks - Repair Kit Discontinured Information | (not specified) | |
Flood Zones, Cars in dirt carried in - drain/refill differential, clean/repack wheel bearings | (all models) | |
Front and Rear Axle Spring Clip Nut Wrench Details of Special Tool ST-786 | All Models | |
Front Axle and Steering Gear - Service Slide Films Information | (not specified) | |
Front Axle Installation Correct Orientation | (not specified) | |
Front Axle Spring Special Parts, Stiffer Spring | Packard Six and Eight | |
Front Axle Trunnion - Bracket Spring Replacement | 626-633-640-726-723-740 | |
Front Spring Striking Bump stop Adjustment | (not specified) | |
Front Spring Trunnion Bracket New Design | 526-443 | |
Front Springs - Not Interchangeable center bolt location - 1001 vs. 7th rear, reiterated | 9th-10th | |
Front Springs - Not Interchangeable center bolt location - also applies to 1001 vs. 7th rear | 9th-10th | |
Front Stabilizer Equipment- Roll Bar Installation | 120 | |
Front Steering Knuckle - Stops Changes in stop location | 725-733, 740-745 | |
Front Wheel - Bearing Lubrication | 9th Series | |
Front Wheel Alignment Overviews and Tools | 126-133; 226-233; 136-143; 326-333; 236-243; 426-433; 326-343; 526-533; 443 | |
Hoo-Dye Shock Absorbers Document Missing | (not specified) | Trade Letter No. 2062 |
Lovejoy Shock Absorbers Document Missing | (not specified) | Trade Letter No. 2076 |
Lubricants - Whitmores and Chassis Oil Information and Warnings | (not specified) | |
Lubrication of Chassis Springs Over Lubrication | (not specified) | |
Lubrication, Steering and Transmission unusually low temperatures - seasonal weight change | (not specified) | |
Lubricator Valve Spring Leaking | (not specified) | |
Oil Seals, Leather dry installation damage - soak in engine oil | (all models) | |
Packard and Delco Lovejoy Shock Absorber Fluid Recommendations | 3rd thru 12th Series | |
Packard and Delco Lovejoy Shock Absorber Fluid Recommendations | 6th thru 14th Series | |
Packard-Bijur Chassis Lubrication System Introduction and Information | (not specified) | |
Rear Axle - Springs Special Load Rate | Light Eight (900) | |
Rear Springs Determining Part Numbers | (not specified) | |
Rear Springs Three Different Spring Rates | (not specified) | |
Ride Control Information and Description | 9th Series | |
Ride Quality Complains Recommendations | 6th, 7th and 8th Series | |
Ride Quality Adjusting Shock Absorbers | 640-645 | |
Shock Absorber - Adjustments New Valves | (not specified) | |
Shock Absorber - Expansion Cups Changes | (not specified) | |
Shock Absorber - Expansion Tanks Installation and Clarification | (not specified) | |
Shock Absorber - New Type Adjustment and Construction | 626; 633; 645 | |
Shock Absorber Clarification on metering valve | (not specified) | |
Shock Absorber Overview and Service Details | 8th Series | |
Shock Absorber Adjustment Metering Valves, Information | (not specified) | |
Shock Absorber Adjustment Metering Valves, Information | (not specified) | |
Shock Absorber Connecting Link Puller Details of Special Tool ST-790 | 826-840 | |
Shock Absorber Expansion Tank New Reserve Tank | (not specified) | |
Shock Absorber Filler Plug New Filler Plug, Vent | (not specified) | |
Shock Absorber Fluid Delco-Lovejoy vs. Houdaille - part reference | (not specified) | |
Shock Absorber Fluid Gun new special tool - dual-action | (not specified) | |
Shock Absorber Links rattles - replace grommet/bushing/sleeve, new tool | 900 1001-2 1100-1-2 | |
Shock Absorber Valves - Standard Equipment reference chart | 8th-10th | |
Shock Absorber Description and Adjustment | (not specified) | |
Shock Absorbers - Change in Manufacturer Hoo-dye to Lovejoys | (not specified) | |
Shock Absorbers - Change Over Equipment Information | 6th and 7th Series | |
Shock Absorbers - Dull Knock Compression Valves | (not specified) | |
Shock Absorbers - Filling Method to fill | (not specified) | |
Shock Absorbers - Metering Valves Adjustments and Fluid Checks | (not specified) | |
Shock Absorbers - New Type O & S superseded by Delco - adjustment, installation | 8th-11th | |
Shock Absorbers - Noise Inspection, Correction | (not specified) | |
Shock Absorbers - Rear Noise Replacement Units | Light Eight (900) | |
Shock Absorbers - Rear Noise Replacement Units | Light Eight (900) | |
Shock Absorbers - Squeak Ride Control Valve | 9th Series | |
Shock Absorbers Lovejoy, installation/filling - valves/metering identification, part reference | 9th-11th | |
Shock Absorbers Settings | 826-833; 840-845 | |
Shock Absorbers Adapting Either Series Shock to earlier models | 6th and 7th Series | |
Shock Absorbers Expansion Tanks | 6th and 7th Series | |
Shocks and Springs - Ride Quality Changes | 640, 645 | |
Spring - Guarantee Information | All Models & Trucks | |
Spring Cover - Lubricant Information | (not specified) | |
Spring Covers Document Missing | (not specified) | Trade Letter No. 2073 |
Springs - Eight Series Part Numbers and Load Rates | Eighth Series | |
Springs and Shackles Overview, Rate, Part Numbers | Light Eight (900) | |
Stabilator Noise Remedy | 526-533-443 | |
Steering - Connecting Rod Ball Joints Adjustment Change, Reduced Rattle | Twelve; Light Eight (900) | |
Steering - Free Up Correcting Hard Steering | (not specified) | |
Steering - Gear Box Information, Overview | Light Eight (900) | |
Steering Adjustment 1,000 mile inspection | (not specified) | |
Steering Box - Lubricant Summer Weather | (not specified) | |
Steering Box - Worm and Gear Assembly Plating Production Change, Replacement Parts | 7th, 8th and 9th Series | |
Steering Connecting Rod - Rear Joint New Joint Style | First and Second Series, Twin Six | |
Steering Data alignment specifications - reference chart | 1st-14th 120-120B | |
Steering Gear Lubricants heavy base no longer needed - use rear axle oil | (all models) | |
Steering Gear, Instructions for Adjusting the Worm and Roller Type eliminating rattles, stiff action - proper procedure | 903-4-5-6 1003-4-5-6 1103-4-5-7-8 | |
Steering Knuckle Ball Bearings Shims, New Parts | (not specified) | |
Steering Knuckle Pin Puller Tool | (not specified) | |
Steering Levers Geometry Change | Light Eight (900) | |
Steering Post Adjustment Changing Steering Wheel Position | (not specified) | |
Steering Post Nut new special tool - used with wheel puller | (all models) | |
Steering Problems Overview, Problem Diagnosis, Adjustments | (not specified) | |
Steering Wheel - Moving Adjustments to accommodate large drivers | (not specified) | |
Steering Wheel Position raise/lower - three different column brackets | (not specified) | |
Steering Wheel Puller, New Style new special tool - use with post nut | (all models) | |
Steering Wheel Screws Inspection | (not specified) | |
Steering Worm Nut Improvements, Changes | Packard Six | |
Straightening Forgings Bent In Service Recommendation to not use any heat | (not specified) | |
Suspension Spring Clips Inspection at First Service | (not specified) | |
Tapered Roller Bearings - Adjustment Proper Adjustment | (not specified) | |
Tire Wear Document Missing | (not specified) | SL Vol. 2, No. 13 |
Torque Arm - Noise Improvements | Single Six | |
Trunnion Bracket Retrofit | 526-443 | |
Trunnion Brackets Document Missing | (not specified) | SL Vol. 3, No. 9 |
Wheel Alignment Document Missing | (not specified) | SL Vol. 1, No. 6 |
Wheel Castor Specification Change | 12th Series |
SC = Service Counselor | SL = Service Letter | STB = Service Technical Bulletin | SSB = Studebaker Service Bulletin |
NOTE: These PDFs were created from High Quality Scans. It is recommended that you Right Click on the link(s) above and do a "Save Target As". This will download the PDF to your machine rather than trying to open and view it over the web.
Disclosures & Disclaimers
Though previously published elsewhere, this work is provided with my full permission for display on the PackardInfo.com website and the personal use of visitors to that site. Any other unauthorized use, however, is expressly prohibited and may be subject to prosecution.
Also, because this index was compiled from documents published by the factory, neither the author nor PackardInfo.com are responsible for errors in content arising from source information.
